Insert the bolt from the outside of the small hole in the flange, and then pass it into the diaphragm hole (pay attention to the direction of the diaphragm. The diaphragm is composed of many single sheets, rivets and rivet washers. The rivet washers should be in contact with the buffer sleeve, otherwise Will affect the service life of the rivet group).
The serpentine spring coupling tooth type is curvilinear: when the load is small, the straight part of the serpentine spring is basically parallel to the connected axis.
The serpentine spring coupling uses serpentine springs divided into one or several groups and is embedded in the teeth on the flange of the two-part coupling to realize the connection of the two halves of the coupling.
The serpentine spring coupling is a structural metal.It relies on serpentine springs to transmit torque.
Coupling is a mechanical component that is mainly used to connect two rotating shafts in mechanical transmission to transmit torque or rotation angle;
Coupling refers to a device that connects two shafts or a shaft and a rotating part, and rotates together in the process of transmitting movement and power, and does not disengage under normal conditions.Sometimes it is also used as a stabilizing device to prevent the connected parts from being subjected to excessive loads and play a role in overload protection.
The serpentine spring coupling is a well-designed non-metallic coupling that relies on serpentine springs to transmit torque.
Before installing the diaphragm elastic coupling, clean the end faces of the two shafts and check the coordination of the key grooves on the end faces; after installation, it is necessary to check all the screws for a normal operation. If it is found to be loose, it needs to be tightened. Repeat several shifts. To be sure it will not loosen.